| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN OFF TANK
|
| 2 |
|
DISCONNECT FUEL LINE
|
| 3 |
|
OPEN TANK STRAP
|
| 4 |
|
REMOVE TANK
|
| 5 |
|
DISCONNECT THE ANDERSON PLUG
|
| 6 |
|
REMOVE THE 2 BOLTS HOLDING THE REGULATOR TO FRAME
|
| 7 |
|
PULL THE VAC HOSE TO DISCONNECT IT FROM THE REGULATOR
|
| 8 |
|
PULL THE FUEL LINE TO DISCONNECT IT FROM THE REGULATOR
|
| 9 |
|
LOCATE AND PULL TO DISCONNECT THE WIRE CONNECTOR
|
| 10 |
|
LOCATE AND PULL TO DISCONNECT THE OTHER WIRE CONNECTOR
|
| 11 |
|
THE REGULATOR IS NOW FREE FROM THE MACHINE.
|
| 12 |
|
PUT THE REGULATOR IN A VICE TO HOLD IN PLACE.
|
| 13 |
|
REMOVE THE FUEL LOCKOFF AND FUEL HOSE FROM THE REGULATOR.
| Wrench-5/8 in |
|
|
| 14 |
|
REMOVE THE BRASS VAC LINE FITTING FROM THE REGULATOR.
| Wrench-7/16 in |
|
|
| 15 |
|
PULL THE VAC LINE FITTING FROM THE REGULATOR.
|
| 16 |
|
REMOVE THE BRASS FUEL LINE FITTING FROM THE REGULATOR.
| Crescent wrench |
|
|
| 17 |
|
PULL THE FUEL LINE FITTING FROM THE REGULATOR.
|
| 18 |
|
REMOVE THE BAD REGULATOR FROM THE VICE.
|
| 19 |
|
WRAP ALL THE BRASS FITTINGS THAT WERE REMOVED FROM THE BAD REGULATOR IN TEFLON (PLUMBERS) TAPE.
| Teflon tape |
|
|
| 20 |
|
REVERSE STEPS 13 THRU 17 TO REINSTALL ALL BRASS FITTINGS. NOTE: THE FUEL LINE FITTING MUST BE IN THE POSITION SHOWN HERE.
|
| 21 |
|
TURN NEW REGULATOR OVER IN VICE TO SHOW IDLE ADJUSTMENT SCREW.
|
| 22 |
|
USING AN ALLEN WRENCH OR SMALL SCREWDRIVER, TURN IN ADJUSTMENT DOWNWARD 2 FULL REVOLUTIONS TO INCREASE THE FUEL CAPACITY.
| Screwdriver-phillips |
|
|
| 23 |
|
REVERSE STEPS 6 THRU 10 TO INSTALL THE REGULATOR ON THE MACHINE. REVERSE STEPS 1 THRU 5 TO REINSTALL THE PROPANE TANK AND RECONNECT THE BATTERIES.
|
| 24 |
|
TURN THE PROPANE TANK ON. TURN THE KEY TO START THE MACHINE. IF IT DOESN'T START AFTER A FEW ATTEMPTS, TURN THE IDLE SCREW UP (STEP 22) A BIT MORE. ADJUST SCREW A LITTLE AT A TIME UNTIL MACHINE STARTS AND RUNS GOOD. NOTE: CHECK CO EMISSIONS TO MAKE SURE THEY ARE BELOW 100PPM. IF NOT, ADJUST THE IDLE SCREW OUTWARD A LITTLE AT A TIME UNTIL CO LEVEL IS CORRECT.
|